Command Outdoor Light Clips Clear 1 EA

Command

To apply 1 Works best for smooth surfaces. Important: apply to a clean and dry surface. To clean, use a cloth dampened with water or isopropyl rubbing alcohol. Do not use household cleaners. Separate strips. 2 Remove blue liner. Press adhesive to clip. 3 Remove black "wall side" liner. 4 Press firmly along the entire clip for 30 seconds. Wait 1 hour before use. To remove 1 Never pull strip towards you. 2 Hold clip gently to prevent clip from snapping fingers. DO NOT press clip against wall. 3 Stretch straight down along wall at least 15 cm (6 in) until strip releases from wall. Important: failure to follow instructions carefully may cause damage! Save instructions for damage-free removal or visit commandstrips.ca Note: apply to surfaces above -9°C (15°F). May lose adhesion below -29°C (-20°F) or above 51°C (125°F). Intended for outdoor use only. Not recommended for use on rough surfaces, such as cement board, brick or rough-sawn wood. Not intended for picture hanging. Use one clip for every 61 cm (2 feet) of lights. Clips can be reused with Command® Small Outdoor Foam Strips.



Calories	% Daily Value
Fat
Saturated
+ Trans
Polyunsaturated
Omega6
Omega3
Monounsaturated
Carbohydrate
Fibre
Sugars
SugarAlcohols
Protein
Cholesterol
Sodium
Potassium
Calcium
Iron

We seek to be accurate with respect to the ingredients, nutritional information, product images and descriptions listed on our website, however, this information may change from time to time. Please always refer to the product package for the most current and accurate ingredient and nutrition information or other product information.